Wicu extra pipe (insulation)
Every heating engineer knows the problem. Wicu-Extra tube is very difficult to re-isolate at deflections, tees, etc., unless you have the expensive fittings.
If you e.g. If you want to solder in a bow, you first lengthen the insulating layer appropriately, depending on the soldering technique hard or soft. Then you cut about 20 cm further insulation around and turn it so that it is separated from the rest of the insulation. Now cut off the insulation with the knife at the front end at a 45 ° angle and remove the section piece. At the other end of the pipe to repeat the process. Now you can insert the arc and solder. After soldering or cooling down I push now the two loose 45 ° pieces over the sheet together, some glue between or Coroplast over, and already one has professionally nachisoliert the bow, the two free straight places can be easily with the remaining Isolierabsschnitten nachisolieren ,
