Make your own protective film for the mobile phone
Recently I bought a protective film for my mobile phone. After about a week, the film went off slowly. It occurred to me that I can make one myself.
Each of you must have a roll of thick Tesafilm (about 5 cm). You have to open it and glue it to a table, but only the beginning. Then you roll the tesa a little further.
Now you need a window puller, it makes you wet with some water at the beginning so that it can slide better. Now you have to take the phone and glue the top of the display. Then you take the window puller and pull the Tesa on the display.
It's best if you do it slowly. Make sure that there are no bubbles.
Now you have to cut off the Tesa. Now you want to know how you get the remainders left on the display.
Quite simply, you take a needle and drive along the edge of the cell phone. But be careful that you do not scratch the phone! Now you can make the rest of the Tesa from the phone.
So that you can hear everything when making a call, you can also make a few small holes with the needle on the receiver. But always slowly and carefully.
You also need patience, but works quite well.
If you turn off the tesa glue traces back. You can easily remove the traces with a piece of paper and nail polish remover.
P.S The protective film can last up to 3 months or more.
Have fun sticking
